Cisco Catalyst 3650 Series

Assigns an IP precedence value to the classified traffic.
The range is 0 to 7. You also can enter a mnemonic name
for a commonly used value.
precedence precedence-value1...value4
Identifies a specific QoS group value as a match criterion.
The range is 0 to 31.
qos-group qos-group-value
Identifies a specific VLAN as a match criterion. The range
is 1 to 4095.
vlan vlan-id
Command Default
No match criteria are defined.
Command Modes
Class-map configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
The class-map class-map-name, cos cos-value, qos-group
qos-group-value, and vlan vlan-id keywords were added.
Cisco IOS XE 3.3SE
Usage Guidelines
The match command is used to specify which fields in the incoming packets are examined to classify the
packets. Only the IP access group or the MAC access group matching to the Ether Type/Len are supported.
If you enter the class-map match-anyclass-map-name global configuration command, you can enter the
following match commands:
•
match access-group name acl-name
The ACL must be an extended named ACL.Note
•
match ip dscp dscp-list
•
match ip precedence ip-precedence-list
The match access-group acl-index command is not supported.
To define packet classification on a physical-port basis, only one match command per class map is supported.
In this situation, the match-any keyword is equivalent.
For the match ip dscp dscp-list or the match ip precedence ip-precedence-list command, you can enter a
mnemonic name for a commonly used value. For example, you can enter the match ip dscp af11 command,
which is the same as entering the match ip dscp 10 command. You can enter the match ip precedence critical
command, which is the same as entering the match ip precedence 5 command. For a list of supported
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
648
match (class-map configuration)