Cisco Catalyst 3650 Series User Manual

mpls ip default-route
To enable the distribution of labels associated with the IP default route, use the mpls ip default-route command
in global configuration mode.
mpls ip default-route
Syntax Description
This command has no arguments or keywords.
Command Default
No distribution of labels for the IP default route.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.1
Usage Guidelines
Dynamic label switching (that is, distribution of labels based on routing protocols) must be enabled before
you can use the mpls ip default-route command.
Examples
The following example shows how to enable the distribution of labels associated with the IP default route:
Switch# configure terminal
Switch(config)# mpls ip
Switch(config)# mpls ip default-route
Related Commands
DescriptionCommand
Enables MPLS forwarding of IPv4 packets along
normally routed paths for the platform.
mpls ip (global configuration)
Enables MPLS forwarding of IPv4 packets along
normally routed paths for a particular interface.
mpls ip (interface configuration)
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
376
mpls ip default-route

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)