port-channel min-links
To define the minimum number of LACP ports that must be bundled in the link-up state and bundled in the
EtherChannel in order that a port channel becomes active, use the port-channel min-links command in
interface configuration mode. To return to the default setting, use the no form of this command.
port-channel min-links min_links_number
no port-channel min-links
Syntax Description
The minimum number of active LACP ports in the port channel. The range
is 2 to 8. The default is 1.
min_links_number
Command Default
None
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
An LACP channel group can have up to 16 Ethernet ports of the same type. Up to eight ports can be active,
and up to eight ports can be in hot-standby mode. When there are more than eight ports in an LACP channel
group, the device on the controlling end of the link uses port priorities to determine which ports are bundled
into the channel and which ports are put in hot-standby mode. Port priorities on the other device (the
noncontrolling end of the link) are ignored.
The port-channel min-links command must specify a number a less than the number specified by the lacp
max-bundle command.
Use the show etherchannel summary privileged EXEC command to see which ports are in the hot-standby
mode (denoted with an H port-state flag in the output display).
Examples
This example shows how to specify a minimum of three active LACP ports before port channel 2 becomes
active:
Device(config)# interface port-channel 2
Device(config-if)# port-channel min-links 3
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
324
port-channel min-links
To Next Page
Loading...
Need help?
General
