Cisco Catalyst 3650 Series User Manual

vrrs leader
To specify a leader’s name to be registered with Virtual Router Redundancy Service (VRRS), use the vrrs
leader command. To remove the specified VRRS leader, use the no form of this command.
vrrs leader vrrs-leader-name
no vrrs leader vrrs-leader-name
Syntax Description
Name of VRRS Tag to lead.
vrrs-leader-name
Command Default
A registered VRRS name is unavailable by default.
Command Modes
VRRP configuration (config-if-vrrp)
Command History
ModificationRelease
This command was integrated into Cisco IOS XE Release 2.1.Cisco IOS XE Release 2.1
Examples
The following example specifies a leader's name to be registered with VRRS:
Device(config-if-vrrp)# vrrs leader leader-1
Related Commands
DescriptionCommand
Creates a VRRP group and enters VRRP
configuration mode.
vrrp
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
208
vrrs leader

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)