show debug
To display all the debug commands available on a switch, use the show debug command in Privileged EXEC
mode.
show debug
show debug condition Condition identifier | All conditions
Syntax Description
Sets the value of the condition identifier to be used. Range is between
1 and 1000.
Condition identifier
Shows all conditional debugging options available.
All conditions
Command Default
No default behavior or values.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Release 16.1
Usage Guidelines
Because debugging output is assigned high priority in the CPU process, it can render the system unusable.
For this reason, use debug commands only to troubleshoot specific problems or during troubleshooting sessions
with Cisco technical support staff. Moreover, it is best to use debug commands during periods of lower network
traffic and fewer users. Debugging during these periods decreases the likelihood that increased debug command
processing overhead will affect system use.
Examples
This example shows the output of a show debug command:
Device# show debug condition all
To disable debugging, use the no debug all command.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
947
show debug
To Next Page
Loading...
Need help?
General
