dot1x pae
To set the Port Access Entity (PAE) type, use the dot1x pae command in interface configuration mode. To
disable the PAE type that was set, use the no form of this command.
dot1x pae {supplicant | authenticator}
no dot1x pae {supplicant | authenticator}
Syntax Description
The interface acts only as a supplicant and will not respond to messages that
are meant for an authenticator.
supplicant
The interface acts only as an authenticator and will not respond to any messages
meant for a supplicant.
authenticator
Command Default
PAE type is not set.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
This command was reintroduced.
This command was not supported
in Cisco IOS XE Denali 16.1.x and
Cisco IOS XE Denali 16.2.x
Cisco IOS XE Denali 16.3.1
Usage Guidelines
Use the no dot1x pae interface configuration command to disable IEEE 802.1x authentication on the port.
When you configure IEEE 802.1x authentication on a port, such as by entering the dot1x port-control interface
configuration command, the switch automatically configures the port as an IEEE 802.1x authenticator. After
the no dot1x pae interface configuration command is entered, the Authenticator PAE operation is disabled.
Examples
The following example shows that the interface has been set to act as a supplicant:
Device(config)# interface g1/0/3
Device(config-if)# dot1x pae supplicant
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
748
dot1x pae
To Next Page
Loading...
Need help?
General
