Cisco Catalyst 3650 Series

(Optional) Specifies EtherType DEC-DSM.dsm
(Optional) Specifies EtherType 0x6000.etype-6000
(Optional) Specifies EtherType 0x8042.etype-8042
(Optional) Specifies EtherType DEC-LAT.lat
(Optional) Specifies EtherType DEC-LAVC-SCA.lavc-sca
(Optional) Specifies the LSAP number (0 to 65535) of a
packet with 802.2 encapsulation to identify the protocol of
the packet.
mask is a mask of don’t care bits applied to the LSAP number
before testing for a match.
lsap lsap-number mask
(Optional) Specifies EtherType DEC-MOP Remote Console.mop-console
(Optional) Specifies EtherType DEC-MOP Dump.mop-dump
(Optional) Specifies EtherType DEC-MSDOS.msdos
(Optional) Specifies EtherType DEC-MUMPS.mumps
(Optional) Specifies EtherType DEC- Network Basic
Input/Output System (NetBIOS).
netbios
(Optional) Specifies EtherType Virtual Integrated Network
Service (VINES) Echo from Banyan Systems.
vines-echo
(Optional) Specifies EtherType VINES IP.vines-ip
(Optional) Specifies EtherType Xerox Network Systems
(XNS) protocol suite (0 to 65535), an arbitrary EtherType in
decimal, hexadecimal, or octal.
xns-idp
(Optional) Specifies a class of service (CoS) number from 0
to 7 to set priority. Filtering on CoS can be performed only
in hardware. A warning message reminds the user if the cos
option is configured.
cos cos
Command Default
This command has no defaults. However, the default action for a MAC-named ACL is to deny.
Command Modes
Mac-access list configuration
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
740
deny (MAC access-list configuration)