Cisco Catalyst 3650 Series

show dot1q-tunnel
To display information about IEEE 802.1Q tunnel ports, use the show dot1q-tunnel in EXEC mode.
show dot1q-tunnel [interface interface-id]
Syntax Description
(Optional) Specifies the interface for which to display IEEE 802.1Q tunneling
information. Valid interfaces include physical ports and port channels.
interface interface-id
Command Default
None
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Examples
The following are examples of output from the show dot1q-tunnel command:
Device# show dot1q-tunnel
dot1q-tunnel mode LAN Port(s)
-----------------------------
Gi1/0/1
Gi1/0/2
Gi1/0/3
Gi1/0/6
Po2
Device# show dot1q-tunnel interface gigabitethernet1/0/1
dot1q-tunnel mode LAN Port(s)
-----------------------------
Gi1/0/1
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
1027
show dot1q-tunnel