Cisco Catalyst 3650 Series

service-policy
To apply a filter on incoming or outgoing service discovery information on a service list, use the service-policy
command. To remove the filter, use the no form of the command.
service-policy service-policy-name {IN | OUT}
no service-policy service-policy-name {IN | OUT}
Syntax Description
Applies a filter on incoming service discovery information.
service-policy-name IN
Applies a filter on outgoing service discovery information.
service-policy-name OUT
Command Default
Disabled.
Command Modes
mDNS configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Examples
This example applies a filter on incoming service discovery information on a service list:
Device(config-mdns)# service-policy serv-pol1 IN
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
250
service-policy