Cisco Catalyst 3650 Series User Manual

exporter
To add a flow exporter for a flow monitor, use the exporter command in the appropriate configuration mode.
To remove a flow exporter for a flow monitor, use the no form of this command.
exporter exporter-name
no exporter exporter-name
Syntax Description
Name of a flow exporter that was previously configured.
exporter-name
Command Default
An exporter is not configured.
Command Modes
Flow monitor configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
You must have already created a flow exporter by using the flow exporter command before you can apply
the flow exporter to a flow monitor with the exporter command.
To return this command to its default settings, use the no exporter or default exporter flow monitor
configuration command.
Examples
The following example configures an exporter for a flow monitor:
Device(config)# flow monitor FLOW-MONITOR-1
Device(config-flow-monitor)# exporter EXPORTER-1
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
429
exporter

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)