Cisco Catalyst 3650 Series User Manual

copy startup-config tftp:
To copy the configuration settings from a switch to a TFTP server, use the copy startup-config tftp: command
in Privileged EXEC mode.
copy startup-config tftp: remote host {ip-address}/{name}
Syntax Description
Host name or IP-address of Remote host.
remote host {ip-address}/{name}
Command Default
No default behavior or values.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Release 16.1
Usage Guidelines
To copy your current configurations from the switch, run the command copy startup-config tftp: and follow
the instructions. The configurations are copied onto the TFTP server.
Then, login to another switch and run the command copy tftp: startup-config and follow the instructions.
The configurations are now copied onto the other switch.
Examples
This example shows how to copy the configuration settings onto a TFTP server:
Device: copy startup-config tftp:
Address or name of remote host []?
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
912
copy startup-config tftp:

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)