Cisco Catalyst 3650 Series

autonomic adjacency-discovery
To enable adjacency discovery (neighbor discovery) on an interface, use the autonomic adjacency-discovery
command in interface configuration mode. To disable adjacency discovery, use the no form of this command.
autonomic adjacency-discovery
no autonomic adjacency-discovery
Command Default
Adjacency discovery is not enabled.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.1
Examples
To enable adjacency discovery:
Device(config)# interface Tunnel100
Device(config-if)# autonomic adjacency-discovery
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
888
autonomic adjacency-discovery