Cisco Catalyst 3650 Series

This example shows how to clear the device storage filename:
Device(config)# no vtp file vtpconfig
Clearing device storage filename.
This example shows how to specify the name of the interface providing the VTP updater ID for this device:
Device(config)# vtp interface gigabitethernet
This example shows how to set the administrative domain for the device:
Device(config)# vtp domain OurDomainName
This example shows how to place the device in VTP transparent mode:
Device(config)# vtp mode transparent
This example shows how to configure the VTP domain password:
Device(config)# vtp password ThisIsOurDomainsPassword
This example shows how to enable pruning in the VLAN database:
Device(config)# vtp pruning
Pruning switched ON
This example shows how to enable Version 2 mode in the VLAN database:
Device(config)# vtp version 2
You can verify your settings by entering the show vtp status privileged EXEC command.
Related Commands
DescriptionCommand
Displays general information about VTP management domain, status,
and counters.
show vtp
Enables or disables VTP on an interface.
vtp (interface configuration)
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
1070
vtp (global configuration)