Chapter 37 Configuration of 802.1X DGS-3610 Series Configuration Guide
Since the keyword none enables any dial-up user to pass the
authentication even if the security server has no reply, it is only used as
the backup authentication method. We suggest not using the "none"
identity authentication in general cases. In special case when all possible
dial-up users are trustful, and no delay due to system fault is allowed for
the user's work, it is possible to use none as the last identity authentication
method in case the security server has no reply. And we recommend
adding the local authentication method before the none authentication
method.
Use the local username database for authentication
Do not perform authentication
Use Radius for authentication
The table above lists the AAA line authentication methods supported by our product.
37.6.4.1 Line Authentication Through Local
Database
To configure the line authentication with local database, you need to configure the local
database first. Our product supports authentication based on the local database. To
establish the user name authentication, run the following commands in the global
configuration mode:
Enter the global configuration mode.
username name [password password] or
username name [access-class number]
Establish the user authentication by using password
or access list.
username name [privilege level]
Set the privilege level for the user (optional).
username name [autocommand
command]
Set the automatic command execution after user
login (optional)
Return to the privileged mode.
Confirm the configuration.
To define the local authentication method list and apply it, run the following commands:
Enter the global configuration mode.
To Next Page
Loading...
Need help?
General