Telit Wireless Solutions LE910 - Page 167

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 167 of 509
Mod. 0808 2011-07 Rev.2
+CNMI - New Message Indications To Terminal Equipment
SELINT 2
1
Store in
<mems> -
Send ind
+CMTI
Store in
<mems> -
Send ind
+CMTI
Store in
SIM - Send
ind +CMTI
Store in
<mems> -
Send ind
+CMTI
Store in
<mems> -
Send ind
+CMTI
2
Route msg
to TE:
+CMT
7
Route msg
to TE:
+CMT
1
Store in
SIM - Send
ind +CMTI
Route msg
to TE:
+CMT
1
Store in
<mems> -
Send ind
+CMTI
3
Store in
<mems> -
Send ind
+CMTI
Store in
<mems>-
Send ind
+CMTI
Store in
SIM - Send
ind +CMTI
Route msg
to TE:
+CMT
1
Store in
<mems> -
Send ind
+CMTI
where <mems> is the memory where the received messages are stored (see
+CPMS)
Note
It has been necessary to take the following decision to get over an incoherence
problem, due to the possibility to have contemporaneous different settings of
parameter <ds> in different sessions (see #PORTCFG and +CMUX):
<ds> settings in different sessions
<ds>=1 for session “0”
AND
<ds>=2 for at least one of the other sessions
URC +CDS is shown only on session
“0” and no status report is stored on
SIM
<ds>=0 for session “0”
AND
<ds>=2 for at least one of the other sessions
no URC is shown on any session and
no status report is stored on SIM
7
The SM is not stored!