Telit Wireless Solutions LE910 - Page 228

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 228 of 509
Mod. 0808 2011-07 Rev.2
#RFSTS – Read current network status
SELINT 2
<SD> - Service Domain
0 - No Service
1 - CS only
2 - PS only
3 - CS+PS
<ABND> - Active Band
1 - GSM 850
2 - GSM 900
3 - DCS 1800
4 - PCS 1900
(WCDMA network)
#RFSTS:
[<PLMN>],<UARFCN>,<PSC>,<Ec/Io>,<RSCP>, RSSI>,[<LAC>],
[<RAC>],<TXPWR>,<DRX>,<MM>,<RRC>,<NOM>,<BLER>,<CID>,<IMSI>,
<NetNameAsc>,<SD>,<nAST>[,<nUARFCN><nPSC>,<nEc/Io>]
Where:
<PLMN> - Country code and operator code(MCC, MNC)
<UARFCN> - UMTS Assigned Radio Channel
<PSC> - Active PSC(Primary Synchronization Code)
<Ec/Io> - Active Ec/Io(chip energy per total wideband power in dBm)
<RSCP> - Active RSCP (Received Signal Code Power in dBm)
<RSSI> - Received Signal Strength Indication
<LAC> - Localization Area Code
<RAC> - Routing Area Code
<TXPWR> - Tx Power
<DRX> - Discontinuous reception cycle Length (cycle length in ms)
<MM> - Mobility Management state (for debug purpose only)
0 - NULL
3 - LOCATION UPDATING INITIATED
5 - WAIT FOR OUTGOING MM CONNECTION
6 - CONNECTION ACTIVE
7 - IMSI DETACH INITIATED
8 - PROCESS CM SERVICE PROMPT
9 - WAIT FOR NETWORK COMMAND
10 - LOCATION UPDATE REJECTED
13 - WAIT FOR RR CONNECTION LOCATION UPDATE
14 - WAIT FOR RR CONNECTION MM
15 - WAIT FOR RR CONNECTION IMSI DETACH
17 - WAIT FOR REESTABLISHMENT
18 - WAIT FOR RR ACTIVE
19 - IDLE