Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 229 of 509
Mod. 0808 2011-07 Rev.2
#RFSTS – Read current network status
20 - WAIT FOR ADDITIONAL OUTGOING MM CONNECTION
21 - CONNECTION ACTIVE GROUP TRANSMIT
22 - WAIT RR CONNECTION GROUP TRANSMIT
23 - LOCATION UPDATING PENDING
24 –IMSI DETACH PENDING
25 - RR CONNECTION RELEASE NOT ALLOWED
255 - UNKNOWN
<RRC> - Radio Resource state (for debug purpose only)
0 - CELL DCH
1 - CELL FACH
2 - CELL PCH
3 - URA PCH
4 - IDLE
5 - IDLE CCCH
<NOM> - Network Operator Mode
<BLER> - Block Error Rate (e.g., 005 means 0.5 %)
<CID> - Cell ID
<IMSI> - International Mobile Station ID
<NetNameAsc> - Operator name
<SD> - Service Domain (see above)
<nAST> - Number of Active Set (Maximum 6)
<nUARFCN> UARFCN of n th active set
<nPSC> PSC of n th active set
<nEc/Io > Ec/Io of n th active Set
(LTE network)
#RFSTS:
<PLMN>,<EARFCN>,<RSRP>,<RSSI>,<RSRQ>,<TAC>,<RAC>,[<TXPWR>],<DRX>,<MM
>,<RRC>,<CI
D>,<IM
SI>,[
<NetNa
meAsc>],
<SD>,<ABND>
Where:
<PLMN> - Country code and operator code(MCC, MNC)
<EARFCN> - E-UTRA Assigned Radio Channel
<RSRP> - Reference Signal Received Power
<RSSI> - Received Signal Strength Indication
<RSRQ - Reference Signal Received Quality
<TAC> - Tracking Area Code
<RAC> - Routing Area Code
<TXPWR> - Tx Power (In traffic only)
<DRX> - Discontinuous reception cycle Length (cycle length in ms)
<MM> - Mobility Management state (for debug purpose only; see above)
<RRC> - Radio Resource state (for debug purpose only; see above)
<CID> - Cell ID
<IMSI> - International Mobile Station ID
To Next Page
Loading...
Need help?
General
