Telit Wireless Solutions LE910 - Page 27

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 27 of 509
Mod. 0808 2011-07 Rev.2
The values set by other commands are stored in NVM outside the profile: some of them are
stored always, without issuing any &W, some other are stored issuing specific commands
(+CSAS, #SLEDSAV, #SKTSAV, #ESAV); all of these values are read at power-up.
The values set by following commands are stored in the profile base section; they depend on the
specific AT instance:
DTE SPEED
+IPR
COMMAND ECHO
E
RESULT MESSAGES
Q
VERBOSE MESSAGES
V
EXTENDED MESSAGES
X
POWER SAVING
+CFUN (it does not depend on the specific AT
instance)
DEFAULT PROFILE
&Y
S REGISTERS
S0;S2;S3;S4;S5;S7;S10;S12;S25
The values set by following commands are stored in the profile extended section and they
depend on the specific AT instance (see +CMUX):
+FCLASS
+CSCS
+CR
+CREG
+CLIP
+CRLP
+CRC
+CLIR
+CSVM
+CCWA
+CUSD
+CAOC
+CSSN
+CIND
+CMER
+CPBS
+CMEE
+CGREG
+CGEREP
+CMGF
+CSDH
+CNMI
#QSS
#ECAM
#SMOV
#MWI
#NITZ
#SKIPESC
#CFF
#STIA
+CSTF
+CSDF
+CTZU
+CAPD
+CCWE
+CSIL
+CTZR
#NWEN
#PSNT
#SIMPR
+COLP
#CESTHLCK
$GPSNUM
+CSTA
+NCIH
The values set by following commands are stored in the profile extended section and they don’t
depend on the specific AT instance (see +CMUX):
+CALM
+CRSL
+CMUT