Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 28 of 509
Mod. 0808 2011-07 Rev.2
The values set by following commands are automatically stored in NVM, without issuing any
storing command and independently from the profile (unique values), and are automatically
restored at startup:
The values set by following commands are stored in NVM on demand, issuing specific
commands and independently from the profile:
stored by +CSAS
6
command and restored by +CRES
7
command
stored by #SLEDSAV command
stored by #SKTSAV command and automatically restored at startup; factory default valutes are
restored by #SKTRST command
4
+CSCB is still stored in the profile extended section only for backward compatibility issues: its actual storing and restoring
are accomplished issuing +CSAS and +CRES
5
It is partially stored in NVM; see command description.
6
Both commands +CSAS and +CRES deal with non-volatile memory, intending for it either the NVM and the SIM
storage.
To Next Page
Loading...
Need help?
General
