Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 277 of 509
Mod. 0808 2011-07 Rev.2
AT#FDOR=<mode>[,<FDDel
ayTimer>[,<SCRITimer>]]
This command triggers fast dormancy; if all conditions are passed
successful SCRI will be send towards the network. SCRI will be
sent as a one shot or for every delay timer expiry, depending on the
mode specified.
Parameters:
1 – indicate application driven (1 shot) Fast Dormancy to modem
2 – switch ON autonomous Fast Dormancy (AFD)
3 – switch OFF autonomous Fast Dormancy (AFD) – default value
1..60 – integer value in seconds
0..120 – integer value in seconds
Note: the setting of
is not saved in NVM. The setting of
timers is saved in NVM.
Note: the reject cause from lower layers is reported by the
unsolicited indication:
where
0 - Reject is default cause.
1 - Reject because T323 timer is running
2 - Reject because Protocol Stack is in wrong states.
3 - Reject when No PS signalling connection exists.
4 - Reject when CS signalling connection exists.
5 - Reject when Protocol Stack component (RRC) procedures are
running.
6 - Reject when Network deactivated FD, by not sending timer
T323 in SIB1.
7 - Reject when from lower layers FD STOP Request is received.
8 - Reject when Protocol Stack component (PDCP) rejects the FD
mode.
9 - FD Reject when Protocol Stack component (RLC) buffers are
To Next Page
Loading...
Need help?
General
