Telit Wireless Solutions LE910 - Page 278

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 278 of 509
Mod. 0808 2011-07 Rev.2
10 - Reject due to peer message received when FD procedure is
running.
11 - Reject when there is no PAS RAB is established and if we
receive FD_START_REQ.
12 - Reject due to cell_pch/ura_pch states when v316 is reached
max limit.
13 - Reject due to ongoing/pending Emergency call.
14 - Reject due to ongoing Call re-establishment.
15 - Reject due to Establishment of Full rate TCH Channel.
16 - Reject due to Establishment of Half rate TCH Channel.
17 - Reject due to Establishment of Half rate TCH Channel for
Data Transfer.
18 - Reject due to Location update.
19 - Reject due to MT Paging.
20 - Reject due to other causes, such as Ongoing SS transactions,
etc.
21 -
Reject due to an ongoing CS procedure while the cell does not
support DTM.
22 - Reject due to Originating Conversational call.
23 - Reject due to Originating Streaming call.
24 - Reject due to Originating Interactive call.
25 - Reject due to Originating Background call.
26 - Reject due to Originating Subscribed Traffic call.
27 - Reject due to Terminating Conversational call.
28 - Reject due to Terminating Streaming call.
29 - Reject due to Terminating Interactive call.
30 - Reject due to Terminating Background call.
31 - Reject due to Inter RAT Cell Selection.
32 - Reject due to Inter RAT Cell Change
33 - Reject due to Registration.
34 - Reject due to Detach.
35 - Reject due to Originating Higher Priority.signalling.
36 - Reject due to Originating Low Priority.signalling.
37 - Reject due to Terminating Higher Priority.signalling.
38 - Reject due to Terminating Lower Priority.signalling.
39 -Reject due to Active RAT not being UMTS.
40 - Reject due to Access Stratum being Inactive/Searching.
41 - Reject due to RRC connection is not active.
42 - Reject due to Active Packet Switch connection.
AT#FDOR?
Read command returns “OK” string along with last accepted mode
and timer values, in the format: