Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 283 of 509
Mod. 0808 2011-07 Rev.2
<t3192> - timer 3192
<drxmax>
- discontinuous reception max time (in seconds)
- packed control ack
blocked sequenc countdown max value
alpha parameter for power control
type of channel which shall be used for downlink
measurements for power control
0 - BCCH
1 - PDCH
(The following informations will be printed only for #CSURVEXT=3 setting)
<mstxpwr> - decimal TX power level
<rxaccmin> - decimal RX level access min, range 0 - 63
<croffset> - decimal Cell Reselection Offset, range 0 - 63
<penaltyt> - decimal Penalty Time, range 0 - 31
<t3212> - decimal T3212 Periodic Location Update Timer
<CRH> - decimal Cell Reselection Offset
(For non BCCH-Carrier)
arfcn: <arfcn> rxLev: <rxLev>
where:
- decimal number; it is the RF channel
- decimal number; it is the receiption level (in dBm)
In 3G
uarfcn: <uarfcn> rxLev: <rxLev> mcc: <mcc> mnc: <mnc> scr code:
<scrcode> cellId: <cellId> lac: <lac> cellStatus: <cellStatus> rscp:
<rscp> ecio: <ecio>
<CR><LF><CR><LF><CR><LF>
where:
- the cell carrier frequency designated by UTRA Absolute Radio
Frequency Channel Number
- decimal number; it is the receiption level (in dBm)
- hexadecimal 3-digits number; it is the mobile country code
- hexadecimal 2-digits number; it is the mobile network code
<scrcode> - decimal number; it is the scrambling code