Telit Wireless Solutions LE910 - Page 433

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 433 of 509
Mod. 0808 2011-07 Rev.2
#STIA - SIM Toolkit Interface Activation
SELINT 2
if <cmdType>=64 (OPEN CHANNEL)
an unsolicited notification will be sent to the user:
#STN: <cmdType>[,<text>]
where:
<text> - optional text string sent by SIM
In this case:
• AT#STSR=64,34 can be sent to reject request.
• AT#STGI is accepted anyway.
• AT#STSR=<cmdType>,0 will start connection.
All other commands:
the unsolicited indication will report just the proactive command type:
#STN: <cmdType>
Note: if the call control or SMS control facility in the SIM is activated, when the
customer application makes an outgoing call, or sends an SS or USSD, or an SMS,
the following #STN unsolicited indication could be sent, according to GSM 11.14,
to indicate whether the outgoing call has been accepted, rejected or modified by the
SIM, or if the SMS service centre address or destination has been changed:
#STN: <cmdTerminateValue>,<Result>[,<TextInfo>[,<Number>
[,<MODestAddr>]]]
where
<cmdTerminateValue>
150 - SMS control response
160 - call/SS/USSD response
<Result>
0 - Call/SMS not allowed
1 - Call/SMS allowed
2 - Call/SMS allowed with modification
<Number> - Called number, Service Center Address or SS String in ASCII format.
<MODestAddr> - MO destination address in ASCII format.
<TextInfo> - alpha identifier provided by the SIM in ASCII format.
Note: an unsolicited result code