Usage Guidelines
After entering the location civic-location identifier global configuration command, you enter civic location
configuration mode. After entering the location geo-location identifier global configuration command, you
enter geo location configuration mode.
The civic-location identifier must not exceed 250 bytes.
The host identifier configures the host civic or geo-spatial location. If the identifier is not a host, the identifier
only defines a civic location or geo-spatial template that can be referenced on the interface.
The host keyword defines the device location. The civic location options available for configuration using
the identifier and the host keyword are the same. You can specify the following civic location options in
civic location configuration mode:
• additional-code—Sets an additional civic location code.
• additional-location-information—Sets additional civic location information.
• branch-road-name—Sets the branch road name.
• building—Sets building information.
• city—Sets the city name.
• country—Sets the two-letter ISO 3166 country code.
• county—Sets the county name.
• default—Sets a command to its defaults.
• division—Sets the city division name.
• exit—Exits from the civic location configuration mode.
• floor—Sets the floor number.
• landmark—Sets landmark information.
• leading-street-dir—Sets the leading street direction.
• name—Sets the resident name.
• neighborhood—Sets neighborhood information.
• no—Negates the specified civic location data and sets the default value.
• number—Sets the street number.
• post-office-box—Sets the post office box.
• postal-code—Sets the postal code.
• postal-community-name—Sets the postal community name.
• primary-road-name—Sets the primary road name.
• road-section—Sets the road section.
• room—Sets room information.
• seat—Sets seat information.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
926
location
To Next Page
Loading...
Need help?
General
