Cisco Catalyst 3650 Series

• state—Sets the state name.
• street-group—Sets the street group.
• street-name-postmodifier—Sets the street name postmodifier.
• street-name-premodifier—Sets the street name premodifier.
• street-number-suffix—Sets the street number suffix.
• street-suffix—Sets the street suffix.
• sub-branch-road-name—Sets the sub-branch road name.
• trailing-street-suffix—Sets the trailing street suffix.
• type-of-place—Sets the type of place.
• unit—Sets the unit.
You can specify the following geo-spatial location information in geo-location configuration mode:
• altitude—Sets altitude information in units of floor, meters, or feet.
• latitude—Sets latitude information in degrees, minutes, and seconds. The range is from -90 degrees to
90 degrees. Positive numbers indicate locations north of the equator.
• longitude—Sets longitude information in degrees, minutes, and seconds. The range is from -180 degrees
to 180 degrees. Positive numbers indicate locations east of the prime meridian.
• resolution—Sets the resolution for latitude and longitude. If the resolution value is not specified, default
value of 10 meters is applied to latitude and longitude resolution parameters. For latitude and longitude,
the resolution unit is measured in meters. The resolution value can also be a fraction.
• default—Sets the geographical location to its default attribute.
• exit—Exits from geographical location configuration mode.
• no—Negates the specified geographical parameters and sets the default value.
Use the no lldp med-tlv-select location information interface configuration command to disable the location
TLV. The location TLV is enabled by default.
Examples
This example shows how to configure civic location information on the switch:
Device(config)# location civic-location identifier 1
Device(config-civic)# number 3550
Device(config-civic)# primary-road-name “Cisco Way”
Device(config-civic)# city “San Jose”
Device(config-civic)# state CA
Device(config-civic)# building 19
Device(config-civic)# room C6
Device(config-civic)# county “Santa Clara”
Device(config-civic)# country US
Device(config-civic)# end
You can verify your settings by entering the show location civic-location privileged EXEC command.
This example shows how to configure the emergency location information on the switch:
Device(config)# location elin-location 14085553881 identifier 1
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
927
location