Cisco Catalyst 3650 Series

You can verify your settings by entering the show location elin privileged EXEC command.
The example shows how to configure geo-spatial location information on the switch:
Device(config)# location geo-location identifier host
Device(config-geo)# latitude 12.34
Device(config-geo)# longitude 37.23
Device(config-geo)# altitude 5 floor
Device(config-geo)# resolution 12.34
You can use the show location geo-location identifier command to display the configured geo-spatial location
details.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
928
location