YASKAWA NX100 User Manual

3 Teaching
3.9 Other Job-editing Functions
3-83
149235-1CD
RE-CSO-A031
3.9.6 Searching
When performing editing or confirmation, a search for the job or step can be done. The search can be
done when the cursor is in either the address or instruction area on the JOB CONTENT window.
Searching is an operation by which the cursor is moved to a specific step or instruction in the edit job. A
target point can be instantaneously searched out without using the cursor.
Operation Explanation
1 Select {JOB} under the main
menu.
2 Select {JOB}. The JOB CONTENT window appears.
3 Select {EDIT} under the menu. The pull-down menu appears.
4 Select {SEARCH}. The selection dialog box appears.
5 Select the searching type.
Short Cut
Main Menu
JOB CONTENT
JOB NAMETEST01
CONTROL GROUPR1
0000
0001
0002
0003
0004
0005
0006
NOP
’TEST
MOVJ VJ=50.00
MOVJ VJ=12.50
MOVL V=276
TIMER T=1.00
DOUT OT#(1) ON
MOVJ VJ=100.00
TOOL : 00
STEP NO. : 0003
JOB
EDIT
DISPLAY
UTILITY
TOP LINE
END LINE
SEARCH
ENABEL SPEED TAG
ENABLE POS LVL TAG
Short Cut
Main Menu
JOB CONTENT
JOB NAME : TEST01
CONTROL GROUP : R1
0000
0001
0002
0003
0004
0005
0006
0007
NOP
’This job is test job
MOVJ VJ=50.00
MOVJ VJ=12.50
MOVL V=276
TIMER T=1.00
DOUT OT#(1) ON
MOVL V=138
TOOL : 00
STEP NO. : 0003
JOB EDIT
DISPLAY
UTILITY
LINE SEARCH
STEP SEARCH
LABEL SEARCH
INSTRUCTION SEARCH
147 of 493

YASKAWA NX100 Specifications

General

Manufacturer	YASKAWA
Model	NX100
Operating Temperature	0 to 45°C
Humidity	20 to 80% RH (non-condensing)
Communication Interfaces	Ethernet
Safety Standards	ISO 10218-1
Power Supply	200-230V AC, 50/60Hz
Storage Temperature	60°C