YASKAWA NX100 User Manual

8 Parameter
8.3 Mode Operation Setting Parameters
8-15
149235-1CD
RE-CSO-A031
 S2C166: INSTRUCTION INPUT LEARNING FUNCTION
This parameter specifies whether to set a line of instructions that has been input on the input buffer line
when pressing the first soft key for each instruction. If “PROVIDED” is selected, the instructions are set.
 S2C167: ADDRESS SETTING WHEN CONTROL POWER IS
TURNED ON
This parameter specifies the processing of the job name, step No., and line No. that are set when the
control power supply is turned ON.
 S2C168: JOB LIST DISPLAY METHOD AT JOB SELECTION
These parameters specify the displaying method on the JOB LIST window at job selection.
 S2C169: INITIAL OPERATION OF MANIPULATOR
This parameter specifies the operation speed level of the first section when starting. Specify the
operation speed with the low-speed start (S1CxG044). When starting at low-speed, the manipulator
stops after reaching the indicated step regardless of the cycle setting. Once the manipulator is paused
during the low-speed operation, it moves at teaching speed when restarted.
0: Without learning function
1: With learning function
0: Reproduces the address when power supply is turned ON.
1: Lead address (Line”0”) of the master job.
0: Order of Names
1: Order of Date
0: Specified on the SPECIAL PLAY window. Operates at low speed only when low speed start is
set. Operates at taught speed when not instructed.
1: Starts at low speed after editing regardless of soft key instructions.
304 of 493

YASKAWA NX100 Specifications

General

Manufacturer	YASKAWA
Model	NX100
Operating Temperature	0 to 45°C
Humidity	20 to 80% RH (non-condensing)
Communication Interfaces	Ethernet
Safety Standards	ISO 10218-1
Power Supply	200-230V AC, 50/60Hz
Storage Temperature	60°C