YASKAWA NX100 User Manual

8 Parameter
8.10 Application Parameters
8-52
149235-1CD
RE-CSO-A031
8.10 Application Parameters
8.10.1 Arc Welding
 AxP000: APPLICATION
This parameter specifies the application. Set “0” for arc welding.
 AxP003: WELDING ASSIGNMENT OF WELDING START
CONDITION FILE
This parameter specifies the beginning condition number in the welding start condition file to be
assigned to Power Source 2. Condition files of a lower number are automatically assigned to Power
Source 1. For a system with one Power Source, set “49” (maximum value).
 AxP004: WELDING ASSIGNMENT OF WELDING END
CONDITION FILES
This parameter specifies the beginning condition number in the welding END condition file to be
assigned to Power Source 2. Condition files of a lower number are automatically assigned to Power
Source 1. For a system with one Power Source, set “13” (maximum value).
 AxP005: WELDING SPEED PRIORITY
This parameter specifies whether the welding speed is specified by the “ARCON” instruction, by the
welding start condition file, or by the additional times of the “MOV” instruction.
 AxP009: WORK CONTINUING
This parameter specifies whether to output an “ARCON” instruction to restart after the manipulator
stopped while the “ARCON” instruction is being output.
 AxP010: WELDING INSTRUCTION OUTPUT
This parameter specifies the beginning number (0 to 12) of the analog output channel to the Power
Source. “0” indicates that no Power Source exists.
Condition file
Power
Source 1
Power
Source 2
Power
Source 1
Power
Source 2
341 of 493

YASKAWA NX100 Specifications

General

Manufacturer	YASKAWA
Model	NX100
Operating Temperature	0 to 45°C
Humidity	20 to 80% RH (non-condensing)
Communication Interfaces	Ethernet
Safety Standards	ISO 10218-1
Power Supply	200-230V AC, 50/60Hz
Storage Temperature	60°C