8 Parameter
8.3 Mode Operation Setting Parameters
8-23
149235-1CD
RE-CSO-A031
S2C317 to S2C321: TIME RESET
These parameters specify whether resetting operation of the specified times is permitted or not.
“PERMIT” is set as the initial value for the work time and motion time.
S2C333: TOOL NO. SWITCHING
This parameter specifies whether tool number switching is permitted or not. If “PERMIT” is selected, 24
types of tools from number 0 to 23 can be switched. If “NOT PERMIT” is selected, only number “0” can
be used.
S2C335: POSITION TEACHING BUZZER
This parameter specifies whether the buzzer sound at position teaching is used or not.
S2C317 : CONTROL POWER ON TIME
S2C318 : SERVO POWER ON TIME
S2C319 : PLAYBACK TIME
S2C320 : WORK TIME
S2C321 : WEAVING TIME
0: Prohibit Resetting
1: Permit Resetting
0: Prohibited
1: Permitted
0: With buzzer
1: Without buzzer
To Next Page
Loading...
Need help?
General
