1 Introduction
1.4 About the Security Mode
1-19
149235-1CD
RE-CSO-A031
1.4 About the Security Mode
1.4.1 Types of Security Modes
The following three types of security modes are available for NX100.
Any operations in the edit mode and the management mode require a password. The password must
contain between 4 and 8 letters, numbers, or symbols.
• Operation Mode
The operator can monitor the line operation and start and stop the manipulator. Repairs,
etc. can be performed if any abnormalities are detected.
• Edit Mode
Teaching, robot jog operations, and editing of jobs and various condition files can be per-
formed in addition to the operations enabled in the operation mode.
• Management Mode
The operator who performs setup and maintenance for the system can set the machine
control parameter, set the time, change the password, etc. in addition to the operations
enabled in the edit mode.
To Next Page
Loading...
