YASKAWA NX100 - Error Message List

11 Error
11.1 Error Message List
11-1
149235-1CD
RE-CSO-A031
11 Error
11.1 Error Message List
Error warns the operator not to advance to the next operation caused by a wrong operation or the
access method when using the programming pendant or an external equipment (computer, PLC, etc.).
When an error occurs, confirm the content of the error then release the error.
To release the error, perform either of the following operations:
• Press [CANCEL] on programming pendant.
• Input alarm/error reset signal (system input).
An error is different from an alarm because it does not stop the robot even if it occurred
while the robot was operated (during playback).
NOTE
Main Menu ShortCut
Cannot insert/modify/delete for axis detachment
477 of 493