YASKAWA NX100 User Manual

11 Error
11.1 Error Message List
11-7
149235-1CD
RE-CSO-A031
2300 -
Cannot teach JOB without group-axis
specification
2310
* Same label exists
XXX Line No.
2340 - Pasted data not found
2360 - Cannot create editing area
2370 -
Cannot cut/copy NOP and END
instructions
2390 - Wrong group axis selection
2400 - Cannot move in cut & paste editing
2430 - Reverse data not found
2440 - Move C-and W-axis to basic position Laser cutting
2450 - Relative JOB not permitted
2470 - Wrong JOB type
2480 - Wrong JOB coordinates setting
2500 - Cannot convert the JOB
2510 - Cannot correct position in the JOB
2520 - Enter JOB name
2530 - Illegal step number
2540 - Enter step number
2550 - Duplicated step number
2551 - Duplicated line number
2560 -
Cannot correct steps of position
variables and REFP
2570 - The step does not contain speed
2580 - The step dose not contain PL/CONT
2590 - Soft limit range over
2600 -
Cannot teach position in concurrent
JOB
2610 - Wrong JOB kind
2620 - Cannot correct play speed in the JOB
2630 - Conveyor position not reset
Error No. Data Error Message Contents
483 of 493

YASKAWA NX100 Specifications

General

Manufacturer	YASKAWA
Model	NX100
Operating Temperature	0 to 45°C
Humidity	20 to 80% RH (non-condensing)
Communication Interfaces	Ethernet
Safety Standards	ISO 10218-1
Power Supply	200-230V AC, 50/60Hz
Storage Temperature	60°C