NEC Xen IPK - Access Code (2-Digit) Assignment

1-1-47, Access Code (2-Digit) Assignment DRAFT 3 Chapter 1 – 81
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-47
System Mode
1
Submode
1
Data No.
47
PC Programming
+ BA
Access Code (2-Digit)
Assignment
General Description
Use this Memory Block to assign a 2-digit number as an Access Code.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + DG to access the Memory Block.
3
Enter the options using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Default Values
Refer to Table in MB 1-1-46 Access Code (1-Digit)
Assignment
4
Enter the Function Number for the Dial Number. Refer to the table in Memory Block 1-1-46 Access Code (1-Digit)
Assignment.
5
PressNto display next dial number successively.
6
Dial 00, and press Nto display next data.
7
PressNto write selected data.
8
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46 Access Code (1-Digit) Assignment
1-1-48 Access Code (3-Digit) Assignment
N
1. Select options from the list of function numbers in Memory Block 1-1-46 Access Code (1-Digit) Assignment, and
assign a number (from 00~99), , or # to each selected function.
• When a function is assigned a 1-digit Access Code, 2-digit Access Codes with the same first digit become invalid
(i.e., if a function is assigned to Access Code 5, Access Codes 50~59, 5, and 5# cannot be used.)
2. To enter # or  as part of an Access Code, press
Q then L or J.
• Use this Memory Block when a 4-Digit Station Numbering Plan is programmed.
3. Use this Memory Block when a 4-Digit Station Numbering Plan is programmed.
4 7 : 2 D G ( 0 0 ) = 0 0 0
T I M E D I S P L A Y
Data
No. Title
Function
No.
Dial No. 0~9
* #