NEC Xen IPK - Section 3 System Data List

December 2004 NEC Business Solutions Ltd
10 – Chapter 1 DRAFT 3 Multiline Terminal Programming
Doc. No.: 8194 - Release 2.0 December 2004
SECTION 3
SYSTEM DATA LIST
The following table provides a complete list of Memory Blocks that are
available in the Xen system. The information is organised by mode,
submode, and then numerically by Memory Block number. The Memory
Block number and name, the default values, and programming values are
provided for each Memory Block.
Table 1-2: System Data
LK 1 System Mode
LK 1 CO Line
Data
No.
Memory Block Name Default Value Programming Values
00 Pause Time Selection 3 sec. 1 sec., 3 sec.
01 DP Interdigit Time Selection Pattern B Pattern A
10 pps: 650 ms
20 pps: 500 ms
Pattern B
10 pps: 800 ms
20 pps: 800 ms
02 Hookflash Time Selection 100 ms. 20 ms., 40 ms., 60 ms.,
80 ms., 100 ms., 140 ms.,
160 ms., 200 ms.
400 ms., 600 ms., 800 ms.,
1 sec., 1.5 sec., 2 sec., 3 sec.,
5 sec.
03 Hold Recall Timer Selection
(Non Exclusive Hold)
60 sec. 25 sec., 45 sec., 60 sec., 90 sec., 120 sec.,
180 sec., 240 sec., No Limit
04 Automatic Redial Time Selection Calling Time = 30 sec
Waiting Time = 60 sec
Call Attempts = 2 times
Calling Time: 1~5 sec
Waiting Time: 1~100 sec
Call Attempts: 1~9 times (3 digit input)
05 Start Timer Selection 10 sec. 2 sec., 10 sec., 20 sec., 30 sec.,
40 sec. , 50 sec., 60 sec., 70 sec.
06 CO/PBX Incoming Ringing Alarm Time
Selection
No Limit 10 sec., 20 sec., 30 sec., No Limit
07 Tie Line Delay Ringing Timer Selection No Limit 10 sec., 20 sec., 30 sec., No Limit
09 Manual Pause Selection No No, Yes
11 System Transfer/Camp-On Selection Yes No, Yes
12 Station Transfer/Camp-On Recall Timer
Selection
60 sec. 25 sec., 45 sec., 60 sec., 90 sec., 120 sec.,
180 sec., 240 sec., No Limit
13 CO Transfer Ring Pattern Selection Pattern C Tone Off, Tone On, Patterns A ~ H
14 CO Transfer Ring Tone Selection Tone A Tones A ~ H
18 System Speed Dial Restriction by Tenant Not Restricted LED On: Not Restricted
LED Off: Restricted
19 Line Selection for Automatic Outgoing
Calls
TG 01 NON, CO, PBX, TIE
TG (01~32), RAB (01~32)
20 DID Digit Length Selection 2 Digits 2, 3, or 4 digits
21 DID Digit Conversion Assignment Yes No, Yes