NEC Xen IPK - Tenant Mode Copy Assignment

6-2, Tenant Mode Copy Assignment DRAFT 3 Chapter 1 – 493
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
6-2
System Mode
6
Submode
2
Data No.
—
Tenant Mode Copy
Assignment
General Description
Use this Memory Block to enable copying data from one tenant to another tenant or multiple
consecutive tenants.
Example: To copy data of Tenant 00 to Tenant 05~07:
1. Enter the original Tenant No. Using the dial pad, press
KK.
2. Press
N.
Display
Programming Procedures
1
Go off-line.
2
Press LK6 + LK2 to access the Memory Block.
3
Enter the tenant to be copied.
Note: Use the following to enter data:
K~I to enter numeric data
U to clear all data when placed at cursor position
Related Programming
No related programming is necessary for this Memory Block.
T N A T — —
‡
T I M E D I S P L A Y
Title
Setting
Data
T N A T 0 0 — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
— —
Æ
T N A T —
T I M E D I S P L A Y
Title
Setting
Data