NEC Xen IPK - Call Forward-Busy Immediately;Delay Selection

448 – Chapter 1 DRAFT 3 Call Forward-Busy Immediately/Delay Selection, 4-42
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
4-42
System Mode
4
Submode
—
Data No.
42
PC Programming
+ BTT
Call Forward-Busy
Immediately/Delay Selection
General Description
Use this Memory Block to specify immediate forward (No) or delay forward (Yes) for an Incoming
CO/PBX call if the station is set for Call Forward Busy.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
No Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK4 +DB to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option.
Note: Use the following to change option:
Rto select next Tel Port No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-2-22 Call Forward No Answer Timer Selection
N
Telephone ports A0~C0 are ports 100~120.
0 1 / 4 2 : B U S Y F W D N O
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Title
Setting
Data