3-00, Trunk Name/Number Assignment DRAFT 3 Chapter 1 – 339
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
3-00
System Mode
3
Submode
—
Data No.
00
PC Programming
+ BCT
Trunk Name/Number
Assignment
General Description
Use this Memory Block to specify telephone name/number for the CO/PBX lines accommodated
so that the information is displayed when the CO/PBX Line is seized, or during an incoming call.
With IPK R2000 and above this memory block is not applicable.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Number
Name
LK 5
LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK3 + KK to access the Memory Block.
3
Use the dial pad to enter data.
Note: Use the following enter data:
J to moves the cursor left
L to moves the cursor right
K~I to numeric keys for entering data
Q to generate a - (hyphen)
U to generate a space (clear after hold)
R to go to the next CO/PBX Line No.
Default Values
Not Specified
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
When a name is selected, refer to Section 7, Character Code Tables, 7.1 Dial Pad Character Assignment on page 1-541 to
get the character codes.
0 1 /
T I M E D I S P L A Y
CO/PBX No.
(01~64)
Setting Data
(13 digits maximum)
To Next Page
Loading...
