3-21, Tie Line Length of Wink Signal Selection DRAFT 3 Chapter 1 – 359
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
3-21
System Mode
3
Submode
—
Data No.
21
PC Programming
+ ALM
Tie Line Length of Wink
Signal Selection
General Description
Use this Memory Block to specify the duration of a wink pulse that is sent to another system.
Display
Settings
(Page 1)
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
30 ms. 60 ms. 90 ms. 120 ms.
LK 5
LK 6 LK 7 LK 8
150 ms.
180 ms. 210 ms. 240 ms.
(Page 2)
LK 1LK 2LK 3LK 4
270 ms. 300 ms. 330 ms. 360 ms.
LK 5 LK 6 LK 7 LK 8
390 ms. 420 ms. 450 ms. 480 ms.
Programming Procedures
1
Go off-line.
2
Press LK3 + N + BA to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
S to go to the next page
T to go to the previous page
R to go to the next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
0 1 / 2 1 : W I N K 1 8 0 | 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Page
No.
Setting
Data
Wink Pulse Sending
Receiving Side
Incoming Signal Detection
Time
DC Loop Supervision
To Next Page
Loading...
