340 – Chapter 1 DRAFT 3 Trunk Status Selection, 3-02
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0
December 2004
3-02
System Mode
3
Submode
—
Data No.
02
PC Programming
+ BCT
Trunk Status Selection
General Description
Use this Memory Block to specify whether a CO/PBX line is used for call origination and
termination or termination only.
Display
Programming Procedures
1
Go off-line.
2
Press LK3 +N+ KBto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
R to go to the next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
0 1 / 0 2 O U T & I N
T I M E D I S P L A Y
Data
No.
CO/PBX
No.
(01~64)
Title
To Next Page
Loading...
