NEC Xen IPK - Station Speed Dial Memory Clear

516 – Chapter 1 DRAFT 3 Station Speed Dial Memory Clear, 8-3
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
8-3
System Mode
8
Spd-Clr-Sta
3
Data No.
—
PC Programming
+ BE
Station Speed Dial Memory
Clear
Use this Memory Block to clear the Station Speed Dial memories of all programmed Speed
Dial numbers.
N
Before programming this procedure, please ensure you understand completely the
affect of erasing all Station Speed Dial buffers in the system.
Display
Programming Procedures
1
Go off-line.
2
Press LK8 + LK3 to access the Memory Block.
3
When the system display prompt indicates CLR TEL SPD?, the first four CO/PBX lines light red.
4
Press HBIIto enter the fixed password.
Note: When entering the password the top line of CO/PBX LEDs change from red to green each time a number of the password
is pressed.
5
PressNto write the data.
6
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
C L R T E L S P D ?
T I M E D I S P L A Y
WWWW
RedRedRed Red
H =
WWWW
Green Red Red Red
WWWW
B =
Green Green Red Red
WWWW
I =
Green Green Green Red
WWWW
I =
Green Green Green Green