NEC Xen IPK - Tie Line Delay Ring Pattern Selection

1-1-53, Tie Line Delay Ring Pattern Selection DRAFT 3 Chapter 1 – 91
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-53
System Mode
1
Submode
1
Data No.
53
PC Programming
+ ALN
Tie Line Delay Ring Pattern
Selection
General Description
Use this Memory Block to select a ringing pattern for incoming calls on a Tie line after the timeout
set in Memory Block 1-1-07.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3 LK 4
Ring Pattern A Ring Pattern B
Ring Pattern C Ring Pattern D
LK 5 LK 6 LK 7 LK 8
Ring Pattern E Ring Pattern F Ring Pattern G Ring Pattern H
(Page 2)
The shaded area indicates
the default setting.
LK 9 LK 10 LK 11 LK 12
No Ring
LK 13 LK 14 LK 15 LK 16
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + EC to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
Sto access the next page
Tto access the previous page
4
Press data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-07 Tie Line Delay Ringing Timer Selection
1-1-34 Tie Line First Ring Pattern Selection
4-01 CO/PBX Ring Assignment (Day Mode)
4-02 CO/PBX Ring Assignment (Night Mode)
5 3 : T L I P T N C | 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Page
No.