NEC Xen IPK - Digit Matching Table to Normal Dial Assignment

1-1-66, 8-Digit Matching Table to Normal Dial Assignment DRAFT 3 Chapter 1 – 107
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-66
System Mode
1
Submode
1
Data No.
66
PC Programming
+ AC
8-Digit Matching Table to
Normal Dial Assignment
General Description
Use this Memory Block to assign the 8-Digit Matching Table by class for normal dialling as used
or unused. If unused is assigned, the system does not check during normal dialling even if
Memory Block 1-1-61 8-Digit Matching Table to Class Assignment is programmed.
Display
Settings
(Page 1) (Page 2)
LK 1 LK 2 LK 3 LK 4 LK 1 LK 2 LK 3 LK 4
There is no
default setting.
Table 00 Table 01 Table 02 Table 03 Table 08 Table 09 Table 10 Table 11
LK 5 LK 6 LK 7 LK 8 LK 5 LK 6 LK 7 LK 8
Table 04 Table 05 Table 06 Table 07 Table 12 Table 13 Table 14 Table 15
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + FF to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option.
Note: Use the following to enter data:
Sto access the next page.
Tto access the previous page.
Each time a CO/PBX line key is pressed, the LED toggles between On
and Off.
Default Values
Tables 00~15 Used
4
PressNto write the data and advance to the next class. Repeat steps 3 and 4 until last class is assigned.
5
PressNto write the last data.
6
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Section 6 Code Restriction in this chapter.
6 6 : N O R M A L D I A L | 1
T I M E D I S P L A Y
D
a
t
a
No.
S
e
tti
ng
Data
Title
CO/PBX
Line LED
Off On
Data Restricted Not restricted
There is no
default setting.