NEC Xen IPK - Automated Attendant Message Repeat Selection

1-4-16, Automated Attendant Message Repeat Selection DRAFT 3 Chapter 1 – 183
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-4-16
System Mode
1
Submode
4
Data No.
16
PC Programming
+ AU
Automated Attendant Message
Repeat Selection
General Description
Use this Memory Block to specify the number of times a message from the Automated Attendant
Is repeated to the calling party.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
One Time Two Times Three Times Four Times
LK 5 LK 6 LK 7 LK 8
Five Times Six Times Seven Times Eight Times
Programming Procedures
1
Go off-line.
2
Press LK1 + LK4 +AFto access the Memory Block.
3 Press the corresponding CO/PBX line to change data option. Default Values
All Messages One Time
4
PressNto write the data and advance to next Automated Attendant Number.
5
After all data is entered, pressNto write the data.
6
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2, Guide to Feature Programming.
1 6 : A A M S G 1 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
A.A. Msg.
No.
1~8