NEC Xen IPK - Automated Attendant Message Day Night Mode Selection

176 – Chapter 1 DRAFT 3 Automated Attendant Message Day Night Mode Selection, 1-4-11
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-4-11
System Mode
1
Submode
4
Data No.
11
PC Programming
+ AU
Automated Attendant Message
Day Night Mode Selection
General Description
Use this Memory Block to specify Automated Attendant messages that are available for use in a
Day/Night Mode setting.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Yes
No
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK4 + AA to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option.
Use the dial pad to enter A.A. message number.
Note: Use the following to enter data:
A~H to enter numerical data
Qto toggle between Day Mode and Night Mode
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2, Guide to Feature Programming.
N
1. This Memory Block must be set to YES for Automated Attendant to be enabled.
1 1 : A A M S G 1 ( D Y ) = N O
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
A.A. Msg.
No.
1~8
Day/Night
Mode