NEC Xen IPK - CO Line Ringing Pattern Selection

1-1-51, CO Line Ringing Pattern Selection DRAFT 3 Chapter 1 – 87
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-51
System Mode
1
Submode
1
Data No.
51
PC Programming
+ BCS
CO Line Ringing Pattern
Selection
General Description
Use this Memory Block to assign the initial ringing pattern for incoming calls on a CO line.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Ring Pattern A Ring Pattern B Ring Pattern C Ring Pattern D
LK 5 LK 6
LK 7 LK 8
Ring Pattern E Ring Pattern F
Ring Pattern G Ring Pattern H
LK 9 LK 10 LK 11 LK 12
No ring
LK 13 LK 14 LK 15 LK 16
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + EA to access the Memory Block.
3
Press corresponding CO/PBX line key to change data.
Note: Use the following to enter data:
Sto access the next page
Tto access the previous page
4
Press Nto write data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-59 Synchronous Ringing Selection
5 1 : C O P T N G | 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Page
No.