NEC Xen IPK - Centralised BLF Send Extension Number Assignment

322 – Chapter 1 DRAFT 3 Centralised BLF Send Extension Number Assignment, 1-15-16
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-15-16
System Mode
1
Submode
15
Data No.
16
PC Programming
+ AW
Centralised BLF Send
Extension Number
Assignment
General Description
Use this Memory Block to assign the Extension Numbers for sending Centralised BLF
messages
.
System Software R2000 or higher is required.
Display
Settings
LK1 LK2 LK3 LK4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
Send Group
1
Send Group
2
Send Group
3
Send Group
4
Send Group
5
Send Group
6
Send Group
7
Send Group
8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK15 + AF to access the Memory Block.
3 Use dial pad keys to enter Table number and Extension No.
Note: Use the following to enter data:
Jto move cursor left.
Lto move cursor right.
K~Ito enter numeric data.
Three Digit Extension Number: 000~999
Four Digit Extension Number: 0000~9999
Tables 001~120 can be assigned.
Default Values
:
All Tables Not Specified
4
Press corresponding CO/PBX line key to select the Send Group No.
5
PressNto write the data, and display the next Memory Block.
6 Repeat Steps 3 and 4 for each Send Group No.
7
Program the next Memory Block or p
ressPto go back on-line.
1 6 : S E N D 0 0 1 =
T I M E D I S P L A Y
Data
No.
Title
Extension
Number
Table No.
(001~120)