NEC Xen IPK - CO Transfer Ring Tone Selection

1-1-14, CO Transfer Ring Tone Selection DRAFT 3 Chapter 1 – 49
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-14
System Mode
1
Submode
1
Data No.
14
PC Programming
+ BCS
CO Transfer Ring Tone
Selection
General Description
Use this Memory Block to select a ring tone for CO transfers.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
Tone A Tone B Tone C Tone D
LK 5LK 6LK 7LK 8
Tone E Tone F Tone G Tone H
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + AD to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
The available tones are:
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-11 System Transfer/Camp-On Selection
1-1-13 Station Transfer/Camp-On Recall Timer Selection
1 4 : C O T R F T O N E A
T I M E D I S P L A Y
Data
No. Title
Setting
Data
Tone Frequency
Tone A 480/600 (Modulation - 16 Hz)
Tone B 480/606 (Modulation - 8 Hz)
Tone C 1024/1285
Tone D 1024
Tone E 500
Tone F 1024/1285 (Modulation - 16 Hz)
Tone G 600/700 (Modulation - 16 Hz)
Tone H 1024 (Envelope - 2 sec.)