December 2004 NEC Business Solutions Ltd
528 – Chapter 1 DRAFT 3 Section 6, Code Restriction
Doc. No.: 8194 - Release 2.0
December 2004
6.3 Memory Blocks
The following related Memory Blocks are used when assigning
Code Restriction.
6.4 Memory Block Description
6.4.1 General
This section describes the function of the Memory Blocks
directly related to Code Restriction. Some Memory Blocks from
the previous list are not described here but are included
because of their effect on Code Restriction (
e.g., Trunk to
Tenant Assignment). Code Restriction is based on Trunk group
and consideration should be given to this Memory Block
because stations are assigned to a tenant, and trunks are
assigned to a Trunk group.
Title Memory Block
Trunk to Tenant Assignment 2-01
Trunk-to-Trunk Group Assignment 3-03
Trunk Type Selection 3-91
PBX/CTX Access Code Assignment I 1-1-24
PBX/CTX Access Code Assignment II 1-1-25
OCC Table Assignment 1-1-67
OCC Table to Trunk Group Assignment 5-03
8-Digit Matching Table to OCC Table Assignment 1-1-68
8-Digit Matching Table to Normal Dial Assignment 1-1-66
8-Digit Matching Table to Trunk Group Assignment 5-02
8-Digit Matching Table Assignment 1-1-60
8-Digit Matching Table to Class Assignment 1-1-61
Code Restriction Class Allow/Deny Assignment 1-1-65
System Speed Dial Restriction by Tenant 1-1-18
System Speed Dial Override by Class Selection 1-1-62
Tie Line Code Restriction Assignment 1-1-69
Code Restriction Class Assignment When Lockout is Set 1-1-70
CO Feature Codes Service for Code Restriction 1-1-82
Trunk Digit Restriction 4-32
Code Restriction Class Assignment (Day Mode) 4-07
Code Restriction Class Assignment (Night Mode) 4-08
Telephone to Tenant Assignment 4-09
To Next Page
Loading...
