NEC Xen IPK - VRS Message Function Assignment

1-8-13, VRS Message Function Assignment DRAFT 3 Chapter 1 – 233
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-8-13
System Mode
1
Submode
8
Data No.
13
PC Programming
+ AR
VRS Message Function
Assignment
General Description
Use this Memory Block to assign the recorded voice prompt Delay Announcement/
Automated Attendant Message to the Voice Recording Service (VRS) channel. Refer to
Memory Block 1-8-12 (VRS Message Recording Time Selection), for the quantity of
messages per channel allowed.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3 LK 4 LK5 LK6 LK7 LK8
NON
V1
(Voice Prompt)
V2
(Voice Prompt)
M1
(Delay Message)
Not Used Not Used Not Used Not Used
(Page 2)
LK 1 LK 2 LK 3 LK 4 LK5 LK6 LK7 LK8
D1
(Day A A)
D2
(Day A A)
D3
(Day A A)
D4
(Day A A)
D5
(Day A A)
D6
(Day A A)
D7
(Day A A)
D8
(Day A A)
The shaded
selection is
the default.
(Page 3)
LK 1 LK 2 LK 3 LK 4 LK5 LK6 LK7 LK8
N1
(Night A A)
N2
(Night A A)
N3
(Night A A)
N4
(Night A A)
N5
(Night A A)
N6
(Night A A)
N7
(Night A A)
N8
(Night A A)
(Page 4)
LK 1 LK 2 LK 3 LK 4 LK5 LK6 LK7 LK8
W1
(Weekend A A)
W2
(Weekend A A)
W3
(Weekend A A)
W4
(Weekend A A)
W5
(Weekend A A)
W6
(Weekend A A)
W7
(Weekend A A)
W8
(Weekend A A)
N
1. The amount of messages per channel that can be assigned is dependant on MB 1-8-12 (VRS Message Time
Selection). Message Location number will not change in MB 1-8-12 to reflect the setting in MB 1-8-12, but the amount
of messages that the system software will allow to be recorded is in accordance to MB 1-8-12.
2. VRS card channel 1~4 is assigned as “VRS = 01” in MB 7-01.
VRS card channel 5~8 is assigned as “VRS = 05” in MB 7-01.
3. A hardware upload of two (2) VRS cards will change their positions, if VRS channels 5~8 are assigned before VRS
channels 1~4 in MB 7-01.
1 3 : V R S 1 / 0 1 = N O N | 1
T I M E D I S P L A Y
Data
No.
Title
Page
No.
VRS
Channel
No.
(1~8)
Message
Location No.
(1~16)
Setting
Data